Data Monitor Mode

NOTE: The following table includes information (items) inapplicable to this vehicle. For information (items) applicable to this vehicle, refer to CONSULT display items.

Monitor item (Unit)	Remarks
BATTERY VOLT (V)	Displays the power supply voltage for power steering control module.
AUTO STOP START FLAG (OK/NG)	Displays a stop/start permission state of the EPS control unit.
AUTO STOP START STATUS (On/CRANK/Off)	Displays a stop/start state received via CAN communication.
Idle Stop Act (On/Off)	Displays a stop/start system activation received via CAN communication.
STEERING MODE (NORML/SPORT)	Displays a steering mode received via CAN communication.
STEERING ANGLE (deg)	Displays the steering angle based on steering angle signal transmitted by CAN communications.
STR ANG SPD (deg/s)	Displays the steering angle speed based on the steering angle signal transmitted by CAN communications.
MOTOR CURRENT (A)	Displays the current value consumed by power steering control module.
MTR REV SPD COMM (rpm)	Displays the power steering motor speed command value.
MTR REV SPD (rpm)	Displays the power steering motor speed.
C/U TEMP (deg.C or deg.F)	Displays the temperature of the power steering control module.
C/U TEMP A (deg.C or deg.F)	Displays the temperature of the power steering control module.
MTR ASSIST (%)	Displays the current percentage of the allowable assist ratio power steering motor.
ESTM VHCL SPD (km/h or mph)	Displays the vehicle speed calculated by the power steering control module.
WARNING LAMP (On/Off)	Power steering warning lamp control status is displayed.
ENGINE STATUS (STOP/RUN/CRANK)	Engine speed is displayed from engine condition signal with CAN communication
VHCL SPD JUDGE (OK/NG)	Displays the receiving status of the vehicle speed signal transmitted by CAN communications.