Work Procedure

SAVING VEHICLE SPECIFICATION
CONSULT Configuration
1. Select "Re/programming, Configuration".
2. Select the operation according to the CONSULT screen.
3. Perform "Before ECU Replacement" of "Vehicle Configuration" to write vehicle specification.
NOTE: If "Before ECU Replacement" of "Vehicle Configuration" cannot be used, use the "Manual Configuration" after replacing BCM. Refer to Description .

GO TO 2.
REPLACE BCM
Replace BCM. Refer to Removal and Installation .

GO TO 3.
WRITING VEHICLE SPECIFICATION
CONSULT Configuration

Select "Re/programming, Configuration". Refer to Description .

GO TO 4.
INITIALIZE BCM (NATS) (IF EQUIPPED)
Perform BCM initialization. (NATS)

WORK END
INITIALIZE TPMS (IF EQUIPPED)
Perform TPMS initialization.

WORK END