DTC Description
CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellent error detection ability. Many electronic control units are equipped onto a vehicle, and each control unit shares information and links with other control units during operation (not independent). In CAN communication, control units are connected with 2 communication lines (CAN-H line, CAN-L line) allowing a high rate of information transmission with less wiring. Each control unit communicate data but selectively reads required data only.
DTC DETECTION LOGIC
|
DTC |
Display item |
Malfunction detected condition |
|
U1010-49 |
CONTROL UNIT(CAN) |
When detecting error during the initial diagnosis of CAN controller to steering force control module. |
POSSIBLE CAUSE
- Steering force control module internal error
Fail-Safe
- System continue normal control.
DTC CONFIRMATION PROCEDURE
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO 2.
- DTC REPRODUCTION PROCEDURE
With CONSULT
- Turn the ignition switch ON.
- Perform self-diagnosis for "EPS/DAST 3".
Is DTC "U1010-49" detected?
YES
Proceed to diagnosis procedure. Refer to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: INSPECTION END