Outline Of Radar Alignment Procedure
- A 4-wheel vehicle alignment must be performed before proceeding with radar alignment procedure.
- Always perform the radar alignment after removing and installing or replacing the ICC sensor.
- If the ICC sensor was removed and installed or replaced, first perform ICC Sensor Initial Vertical Alignment, refer to Description .
WARNING:
Radio waves could adversely affect electric medical equipment. Those who use a pacemaker should contact the electric medical equipment manufacturer for the possible influences before use.
CAUTION:
The system does not operate normally unless the radar alignment is performed. Always perform it.
- Preparation, refer to Work Procedure (Preparation) .
- Preparation, refer to Work Procedure (Preparation) .
- Set the ICC sensor target board (SST: KV99112700) to the correct position in front of the vehicle. Refer to Work Procedure (Setting The ICC Target Board) .
- Set the radar alignment mode ("Calibration of long range radar" on "Work support") with CONSULT, and then perform the adjustment according to the display. Refer to Work Procedure (Radar Alignment) .