DTC Component Inspection (Quantity Control Valve)

1. Turn ignition switch OFF.
2. Disconnect ECM harness connector.
3. Check the resistance between ECM harness connector terminals.

   ECM		Resistance (Ohm)
   +	-
   Terminal
   75	76	0.3 - 1.1

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 2.

1. Disconnect quantity control valve harness connector.
2. Check the resistance between quantity control valve terminals.

   Quantity control valve		Resistance (Ohm)
   +	-
   Terminal
   1	2	0.3 - 1.1

Is the inspection result normal?

YES

INSPECTION END

NO

Replace high pressure fuel pump. Refer to Removal and Installation .