Work Procedure
WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.
- SAVING VEHICLE SPECIFICATION
With CONSULT
- Turn ignition switch ON.
- Select the "HVAC" of "Re/programming, Configuration" with CONSULT.
- Select the "Before Replace ECU" of "Read / Write Configuration", and save or print the current vehicle specification. Refer to Description .NOTE: If "Before Replace ECU" of "Read / Write Configuration" cannot be used, use the "Manual Configuration" after replacing A/C auto amp. to write vehicle specification.
GO TO 2.
- REPLACE A/C AUTO AMP.
- Turn ignition switch OFF.
- Replace A/C auto amp. Refer to Removal and Installation .
GO TO 3.
- WRITING VEHICLE SPECIFICATION
- Turn ignition switch ON.
- Select the "HVAC" of "Re/programming, Configuration" with CONSULT.
- Select the "Manual Configuration" or "After Replace ECU" of "Read / Write Configuration", and write the vehicle specification into the A/C auto amp. Refer to Description .
GO TO 4.
- OPERATION CHECK
Confirm that each function controlled by A/C auto amp. operates normally.
WORK END