Work Procedure

WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION: Fully understand the following items well before the road test;

Precautions: Refer to BCI system service .
System description for BCI: Refer to System Description .
Normal operating condition: Refer to Description .

CHECK BCI SYSTEM SETTING
Check the sonar system operation. Refer to System Description .

GO TO 2.
CHECK BCI SYSTEM SETTING
1. Start the engine.
2. Check that the BCI system setting can be enabled/disabled on the integral switch.
3. Turn OFF the ignition switch and wait for 30 seconds or more.
4. Check that the previous setting is saved when the engine starts again.
GO TO 3.

ACTION TEST FOR BCI

Enable the setting of the BCI system on the integral switch.

Check the BCI operation according to the following table.

Vehicle condition		Action	Buzzer
R range 0 km/h (0 MPH)	If the radar detects an approaching vehicle from the side	Chime sound (single beep) Flashes Blind Spot Warning/Blind Spot Intervention indicator on the side of the approaching vehicle is detected Yellow rectangular frame appears in the display	Single beep
R range 0 km/h (0 MPH)	No approaching vehicle	No action	--

INSPECTION END