Work Procedure

WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Be careful of traffic conditions and safety around the vehicle when performing road test.

CAUTION: Fully understand the following items well before the road test;

Precautions: Refer to Blind Spot Warning/Blind Spot Intervention System Service .
System description for Blind Spot Warning: Refer to System Description .
System description for Blind Spot Intervention: Refer to System Description .
Normal operating condition: Refer to Description .

LDW/LDP SYSTEM ACTION TEST
Perform the LDW/LDP system action test. Refer to Inspection Procedure .

GO TO 2.
CHECK BSW SYSTEM SETTING
1. Start the engine.
2. Check that the BSW system setting can be enabled/disabled on the integral switch.
3. Turn OFF the ignition switch and wait for 5 seconds or more.
4. Check that the previous setting is saved when the engine starts again.
GO TO 3.

BSW SYSTEM ACTION TEST

Enable the setting of the BSW system on the integral switch.
Turn BSW system display ON (Speaker icon is ON at the "Blind spot").
NOTE: Blind Spot Intervention system is OFF.

Check BSW operation according to the following table.

Vehicle condition/ Driver's operation			Action
Vehicle speed (Approx.) [km/h (MPH)]	Turn signal condition	Status of vehicle detection within detection area	Indication on the Blind Spot Warning/Blind Spot Intervention indicator	Indication on the combination meter	Indicator color	Buzzer
Less than approx. 29 (18)	--	--	OFF	Courtesy of NISSAN NORTH AMERICA, INC.	White	OFF
Approx. 32 (20) or more	--	Vehicle is absent	OFF	Courtesy of NISSAN NORTH AMERICA, INC.	White	OFF
	OFF	Vehicle is detected	ON	Courtesy of NISSAN NORTH AMERICA, INC.	White	OFF
	ON (vehicle detected direction)	Before turn signal operates Vehicle is detected	Blink	Courtesy of NISSAN NORTH AMERICA, INC.	Yellow (Blink)	Short continuous beeps
	ON (vehicle detected direction)	Vehicle is detected after turn signal operates	Blink	Courtesy of NISSAN NORTH AMERICA, INC.	Yellow (Blink)	OFF

GO TO 4.

CHECK BLIND SPOT INTERVENTION SYSTEM SETTING
1. Start the engine.
2. Check that the Blind Spot Intervention system setting can be enabled/disabled on the integral switch.
3. Turn OFF the ignition switch and wait for 5 seconds or more.
4. Check that the previous setting is saved when the engine starts again.
GO TO 5.
CHECK DYNAMIC DRIVER ASSISTANCE SWITCH
1. Start the engine.
2. After starting the engine wait for 5 seconds or more.
3. Enable the setting of the Blind Spot Intervention system on the integral switch.
4. Press the dynamic driver assistance switch.
5. Check that the Blind Spot Intervention system display on the combination meter illuminates.
6. Check that the Blind Spot Intervention system display turns OFF when the system is turned OFF by pressing the dynamic driver assistance switch.
7. Check that the Blind Spot Intervention ON indicator turns OFF when the engine starts again.
NOTE:
- The Blind Spot Intervention system display does not illuminate even when the dynamic driver assistance switch is turned ON within approximately 5 seconds after starting the engine.
- When the Blind Spot Intervention system setting is disabled on the integral switch, the Blind Spot Intervention system display is not turned ON by pressing the dynamic driver assistance switch.
INSPECTION END