Blind Spot Warning System Operation Description
WARNING: This page is about a different car, the 2018 Infiniti Q60. However, it is still accessible from the selected car via links, so may be relevant.
- ADAS control unit enables BSW system.
- The ADAS control unit turns on the BSW system when the turned ON by integral switch.
- Side radar detects a vehicle in the adjacent lane, and transmits the vehicle detection signal to ADAS control unit via ITS communication.
- ADAS control unit starts the control as follows, based on a vehicle detection signal, turn signal and dimmer signal transmitted from BCM via CAN communication:
- Blind Spot Warning/Blind Spot Intervention indicator signal and Blind Spot Warning/Blind Spot Intervention indicator dimmer signal transmission to side radar.
- Activates warning buzzer by driver assistance buzzer control module.
- Side radar transmits an indicator operation signal to the Blind Spot Warning/Blind Spot Intervention indicator according to Blind Spot Warning/Blind Spot Intervention indicator signal and Blind Spot Warning/Blind Spot Intervention indicator dimmer signal.
OPERATING CONDITION
- Blind Spot Warning system display (white): ON (Speaker icon ON in "Blind spot" position)
- Vehicle speed: Approximately 32 km/h (20 MPH) or more.
NOTE:
ON/OFF of Blind Spot Warning system is performed with the integral switch.
- After the operating conditions of warning are satisfied, the warning continues until the vehicle speed reaches approximately 29 km/h (18 MPH)
- The Blind Spot Warning system may not function properly, depending on the situation. Refer to Precautions for Blind Spot Warning/Blind Spot Intervention .
- Setting of BSW is performed in synchronization with the log-in function of on-board personal assistant. For details of the log-in function, refer to System Description .