Work Procedure
- WRITING MODE SELECTION
CONSULT Configuration
Select "Re/programming, Configuration" of "MULTI AV".
When writing saved data
GO TO 2.
When writing manually
GO TO 3.
- WRITING VEHICLE SPECIFICATION
Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to display control unit.
CAUTION: Do not perform any operation such as the navigation operation during configuration writing.GO TO 4.
- WRITE VEHICLE SPECIFICATION
Select "Manual Configuration", and write the setting value as shown in the following table to display control unit according to the vehicle specification.
CAUTION:- Grasp vehicle specifications precisely. The control of ECU may not function normally if the specifications are misread.
- Do not perform any operation such as the navigation operation during configuration writing.
NOTE:- The items shown in this list depend on vehicle specifications.
- The config list may not be displayed depending on vehicle specifications. This is not a malfunction.
- If selection items are not displayed on the CONSULT screen, touch "NEXT".
MANUAL SETTING ITEM
Detail
Items
Setting value
DESTINATION
U.S.A
For United States of America
Canada
For Canada
Mexico
For Mexico
NAVIGATION
WITH
Models with navigation system
WITHOUT
Models without navigation system
CAMERA SYSTEM
REAR CAMERA
Models with rear view monitor system
NONE/AVM ph3
Models without camera system
AVM (EXCEPT AVM ph3)
Models with around view monitor system
SONAR TYPE
NONE
Models without sonar system
FRONT&REAR
Models with sonar system
AUDIO AMP TYPE
160W AMP
Models without BOSE system
2ch AMP
Models with BOSE system
GO TO 5.
- PERFORM SELF-DIAGNOSIS
Perform self-diagnosis of CONSULT, and check whether or not DTC "U1223" is detected.
Is DTC "U1223" detected?
YES
GO TO 3.
NO
GO TO 5.
- OPERATION CHECK
Check that the operation of the display control unit and camera images (fixed guide lines and predictive course lines) are normal.
WORK END