LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2018 >> QX30 Essential, AWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (DTC/Circuit Diagnosis) (4 Of 4) >> DTC/Circuit Diagnosis >> DTC P24D6: EVAP Control System Pressure Sensor >> DTC Description >> DTC Detection Logic
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Detection Logic

DTC No.

CONSULT screen terms

DTC detecting condition

DTC

(Trouble diagnosis content)

Malfunction type

P24D6

02

EVAP system pressure sensor/sw B

(EVAP system pressure sensor/switch B circuit range/performance)

GENERAL ELEC MALFUNCTN

Pressure sensor/pressure switch 2 of the evaporative emission control system has a malfunction. There is a general signal fault.

16

CIRC VOLT BELOW THRESHOLD

Pressure sensor/pressure switch 2 of the evaporative emission control system has a malfunction. The limit value for electrical voltage has not been attained.

17

CIRC VOLT ABOVE THRESHOLD

Pressure sensor/pressure switch 2 of the evaporative emission control system has a malfunction. The limit value for electrical voltage has been exceeded.

26

SIG RTE OF CHNG BLW THRESHLD

Pressure sensor/pressure switch 2 of the evaporative emission control system has a malfunction. The signal change rate is below the permissible limit value.

28

SG BS LVL O-OF RNG/ZR AJST FLR

Pressure sensor/pressure switch 2 of the evaporative emission control system has a malfunction. The signal offset is outside the permissible range.

2A

SIGNAL STUCK IN RANGE

Pressure sensor/pressure switch 2 of the evaporative emission control system has a malfunction. There is no signal change.