DTC Detection Logic

NOTE:

If DTC B2604 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to DTC Logic .
If DTC B2604 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Refer to DTC Logic .

DTC No.

Trouble diagnosis name

DTC detecting condition

Possible cause

B2604

PNP/CLUTCH SW

The following states are detected for 5 seconds while ignition switch is ON:

P/N position signal is sent from TCM but shift position signal input (CAN) from TCM is other than P (Park) and N (Neutral)
P/N position signal is not sent from TCM but shift position signal input (CAN) from TCM is P (Park) or N (Neutral)