Work Procedure

WRITING VEHICLE SPECIFICATION
Perform writing vehicle specification.

When writing saved data

GO TO 2.

When writing manually

GO TO 3.
PERFORM WRITING SAVED DATA
With CONSULT
1. Turn Ignition Switch ON.
2. Select "MULTI AV" of "Re/programming, Configuration" with CONSULT.
3. Select "After ECU Replacement", of "Read / Write Configuration", and write the vehicle specification into Display Control Unit.
WORK END
PERFORM WRITING MANUALLY
With CONSULT
1. Turn Ignition Switch ON.
2. Select "MULTI AV" of "Re/programming, Configuration" with CONSULT.
3. Select "Manual Configuration", and write the vehicle specification to Display Control Unit. Refer to Configuration List .
  CAUTION:
  - Thoroughly read and understand the vehicle specification. ECU control may not operate properly if the setting is not correct.
  - The "Setting Value" of this vehicle is as follows: Never select any other value than the setting value shown below. (If there is only 1 item in "Setting Value" that means that item is the only choice for this certain vehicle.)
Work End.