Component Inspection (Throttle Position Sensor)

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform Description .
4. Turn ignition switch ON.
5. Set selector lever to D position.
6. Check the voltage between ECM harness connector terminals under the following conditions.

   ECM			Condition		Voltage
   Connector	Terminal
   F78	43 (TP Sensor 1)	44	Accelerator pedal	Fully released	More than 0.36 V
   				Fully depressed	Less than 4.75 V
   	48 (TP Sensor 2)			Fully released	Less than 4.75 V
   				Fully depressed	More than 0.36 V

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 2.

1. Replace malfunctioning electric throttle control actuator. Refer to EXPLODED VIEW
2. Perform Throttle Valve Closed Position Learning. Proceed to Description .

INSPECTION END