Component Inspection (Accelerator Pedal Position Sensor)
- CHECK ACCELERATOR PEDAL POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Turn ignition switch ON.
- Check the voltage ECM harness connector terminals as per the following.
ECM
Condition
Voltage
Connector
+
-
Terminal
E32
202
(APP sensor 1)
203
Accelerator pedal
Fully released
0.45 - 1.0 V
Fully depressed
4.4 - 4.8 V
195
(APP sensor 2)
196
Fully released
0.22 - 0.50 V
Fully depressed
2.1 - 2.5 V
Is the inspection result normal?
YES
INSPECTION END
NO
Replace Accelerator Pedal Assembly. Refer to Removal and Installation (models without Distance Control Assist System), Removal and Installation (models with Distance Control Assist System).