Component Inspection
- CHECK ICC STEERING SWITCH
- Turn ignition switch OFF.
- Disconnect combination switch (spiral cable) harness connector M302.
- Check resistance between combination switch harness connector terminals under the following conditions.
Combination switch
Condition
Resistance (Ohm)
Connector
Terminals
M302
13 and 16
MAIN switch: Pressed
Approx. 0
DYNAMIC DRIVER ASSISTANCE switch: Pressed
Approx. 270
CANCEL switch: Pressed
Approx. 620
DISTANCE switch: Pressed
Approx. 1, 100
SET/COAST switch: Pressed
Approx. 1, 810
RESUME/ACCELERATE switch: Pressed
Approx. 3, 000
All ICC steering switches: Released
Approx. 5, 420
Is the inspection result normal?
YES
INSPECTION END
NO
Replace ICC steering switch. Refer to Removal and Installation .