Work Procedure
Performing the following procedure can automatically activate recommunication of ECM and BCM, but only when the ECM is replaced with a new one*.
*: New one means a virgin ECM that has never been energized on-board.
(In this step, initialization procedure by CONSULT is not necessary)
NOTE:
- If multiple keys are attached to the key holder, separate them before beginning work.
- Distinguish keys with unregistered key IDs from those with registered IDs.
- PERFORM ECM RECOMMUNICATING FUNCTION
- Install ECM.
- Contact backside of registered Intelligent Key* to push-button ignition switch, then turn ignition switch to ON.
*: To perform this step, use the key that is used before performing ECM replacement.
- Maintain ignition switch in the ON position for at least 5 seconds.
- Turn ignition switch to OFF.
- Check that the engine starts.
GO TO 2.
- PERFORM ADDITIONAL SERVICE WHEN REPLACING ECM
Refer to Work Procedure .
END