Component Inspection

CHECK EVAP CONTROL SYSTEM PRESSURE SENSOR

Turn ignition switch OFF.
Remove EVAP control system pressure sensor with its harness connector.
Always replace O-ring with a new one.
Install a vacuum pump to EVAP control system pressure sensor.

Turn ignition switch ON and check output voltage between ECM harness connector terminals under the following conditions.

ECM			Condition [Applied vacuum kPa (kg/cm ² , psi)]	Voltage (V)
Connector	+	-
	Terminal	Terminal
E20	121	148	Not applied	1.8 - 4.8
			-26.7 (-0.272, -3.87)	2.1 to 2.5 lower than above value

CAUTION:

Always calibrate the vacuum pump gauge when using it.
Never apply below -93.3 kPa (-0.952 kg/cm ² , -13.53 psi) or pressure over 101.3 kPa (1.033 kg/cm ² , 14.69 psi).

Is the inspection result normal?

YES

INSPECTION END

Replace EVAP control system pressure sensor.