Diagnosis Procedure

1. Turn ignition switch OFF.
2. Disconnect push-button ignition switch connector.
3. Check voltage between push-button ignition switch harness connector and ground.

   (+)		(-)	Voltage (V) (Approx.)
   Push-button ignition switch
   Connector	Terminal
   M101	8	Ground	Battery voltage

Is the inspection normal?

YES

GO TO 2.

NO

Check 10 A fuse [No. 10, located in fuse block (J/B)].

NO

Check harness for open or short between push-button ignition switch and fuse.

1. Connect push-button ignition switch connector.
2. Disconnect BCM connector.
3. Check voltage between BCM connector and ground.

   (+)		(-)	Voltage (V) (Approx.)
   BCM
   Connector	Terminal
   M101	73	Ground	Battery voltage
   	91
   	109

Is the inspection normal?

YES

Replace BCM. Refer to Removal and Installation .

NO

GO TO 3.

1. Disconnect push-button ignition switch connector.
2. Check continuity between BCM harness connector and push-button ignition switch harness connector.

   Indicator	BCM		Push-button ignition switch		Continuity
   	Connector	Terminal	Connector	Terminal
   LOCK	M71	91	M101	5	Existed
   ACC		109		6
   ON		73		7

3. Check continuity between BCM harness connector and ground.

   Indicator	BCM		Ground	Continuity
   	Connector	Terminal
   LOCK	M71	91		Not existed
   ACC		109
   ON		73

Is the inspection normal?

YES

Replace push-button ignition switch. Refer to Removal and Installation .

NO

Repair or replace harness.