Component Function Check

1. Turn ignition switch OFF.
2. Disconnect fuel level sensor unit and fuel pump harness connector.
3. Remove fuel level sensor unit. Refer to Removal and Installation .
4. Check resistance between fuel level sensor unit and fuel pump terminals by heating with hot water as shown in the figure, below.

   Courtesy of NISSAN NORTH AMERICA, INC.

   Terminals	Condition		Resistance (k Ohms)
   4 and 5	Temperature [ deg. C (deg. F)]	20 (68)	2.3-2.7
   		50 (122)	0.79-0.90

Is the inspection result normal?

YES

GO TO 2.

NO

Proceed to Diagnosis Procedure .

Check intermittent incident. Refer to Inspection .

Is the inspection result normal?

YES

INSPECTION END

NO

Proceed to Diagnosis Procedure .