Work Procedure

Will CONSULT be used?

Will CONSULT be used?

YES

GO TO 2.

NO

GO TO 3.

WITH CONSULT

1. Turn ignition switch ON.
2. Select "VVEL POS SEN ADJ PREP" in "WORK SUPPORT" mode with CONSULT.
3. Touch "Start" and wait a few seconds.
4. Check that "CMPLT" is displayed on CONSULT screen.
5. Select "VVEL POSITION SEN-B1" or "VVEL POSITION SEN-B2" in "DATA MONITOR" mode with CONSULT.
6. Loosen the VVEL control shaft position sensor mounting bolts (1).

   Courtesy of NISSAN NORTH AMERICA, INC.

7. Turn the VVEL control shaft position sensor (2) clockwise and counterclockwise while monitoring the output voltage of "VVEL POSITION SEN-B1" or "VVEL POSITION SEN-B2" and adjust the output voltage to be within the standard value.

   Voltage:

   500 ± 48 mV

8. Tighten the VVEL control shaft position sensor mounting bolts.

   :	7.0 N.m (0.71 kg-m, 62 in-lb)

9. Reconfirm that the output voltage of "VVEL POSITION SEN-B1" or "VVEL POSITION SEN-B2" is within the standard value.

   Voltage:

   500 ± 48 mV

   NOTE: If it varies from the standard value after the mounting bolts are tightened, perform steps 6 to 8 again.
10. Turn ignition switch OFF and wait at least 10 seconds.
11. Start engine and warm it up to normal operating temperature.
12. Turn ignition switch OFF and wait at least 10 seconds.
13. Perform idle air volume learning. Refer to Description .

INSPECTION END

WITHOUT CONSULT

1. Disconnect VVEL control shaft position sensor harness connector.
2. Remove VVEL actuator motor relay.
3. Turn ignition switch ON, wait at least 5 seconds and then turn it OFF.
4. Reconnect all harness connectors disconnected.
5. Install VVEL actuator motor relay.
6. Turn ignition switch ON and wait at least 5 seconds.
7. Loosen the VVEL control shaft position sensor mounting bolts (1).

   Courtesy of NISSAN NORTH AMERICA, INC.

8. Turn the VVEL control shaft position sensor (2) clockwise and counterclockwise while monitoring the output voltage between the VVEL control module terminals with a tester and adjust the output voltage to be within the standard value.

   VVEL control module				Voltage
   Bank	Connector	+	-
   		Terminal	Terminal
   1	F56	3	6	500 ± 48 mV
   2		5	4

9. Tighten the VVEL control shaft position sensor mounting bolts.

   :	7.0 N.m (0.71 kg-m, 62 in-lb)

10. Reconfirm that the output voltage of VVEL control shaft position sensor is within the standard value.

    VVEL control module				Voltage
    Bank	Connector	+	-
    		Terminal	Terminal
    1	F56	3	6	500 ± 48 mV
    2		5	4

    NOTE: If it varies from the standard value after the mounting bolts are tightened, perform steps 7 to 9 again.
11. Turn ignition switch OFF and wait at least 10 seconds.
12. Start engine and warm it up to normal operating temperature.
13. Turn ignition switch OFF and wait at least 10 seconds.
14. Perform Idle Air Volume Learning. Refer to Description .

INSPECTION END