Active Test Mode

Test Item

Test item	Full spell	Condition
CHECK DECELERATION AIR SWITCHOVER VALVE	CHECK DECELERATION AIR SWITCHOVER VALVE	Combustion engine AT STANDSTILL. Ignition ON.
CHECK ENGINE OIL PUMP VALVE	CHECK ENGINE OIL PUMP VALVE	Combustion engine AT STANDSTILL. Ignition ON.
Check boost pressure control	Check boost pressure control	Engine running at idle
CHECK PURGING SWITCHOVER VALVE	CHECK PURGING SWITCHOVER VALVE	Combustion engine AT STANDSTILL Ignition ON.
Check intake camshaft solenoid	Check intake camshaft solenoid	The ignition is switched ON. Engine running at idle Coolant temperature > 80 deg.C (176 deg.F)
Check exhaust camshaft solenoid	Check exhaust camshaft solenoid	The ignition is switched on. Engine running at idle Coolant temperature > 80 deg.C (176 deg.F)
CAMSHAFT POSITIONER	CAMSHAFT POSITIONER	Apply parking brake. Move selector lever to position 'P' or 'N' on vehicles with automatic transmission. Shift the gearshift lever to neutral on vehicles with manual transmission. During the test the engine speed must be between 2, 700 and 3, 500 RPM.
Check cylinder fuel injectors	Check cylinder fuel injectors	Engine running at idle
Quantity control valve	Quantity control valve	The fuel low pressure circuit is OK. The combustion engine is at idle. All electrical accessories must be switched OFF.
CHECK FUEL HIGH PRESSURE CIRCUIT FOR LEAKTIGHTNESS	CHECK FUEL HIGH PRESSURE CIRCUIT FOR LEAKTIGHTNESS	Ignition ON. Coolant temperature between 75 deg.C and 105 deg.C (167 deg.F and 221 deg.F) Fuel temperature between 40 deg.C and 80 deg.C (104 deg.F and 176 deg.F) Start combustion engine. Combustion engine IDLING Switch off all current consumers. Connect charger for battery.
CHECK FUEL HIGH PRESSURE CIRCUIT	CHECK FUEL HIGH PRESSURE CIRCUIT	Ignition ON. Apply parking brake.
Check fuel pressure and temperature sensor rail pressure	Check fuel pressure and temperature sensor rail pressure	Combustion engine IDLING. Coolant temperature between 75 deg.C (167 deg.F) and 105 deg.C (221 deg.F) All electrical accessories must be switched OFF.
CK ENG AND AC WITH INTEGRATED CONT FAN MOTOR	CHECK COMBUSTION ENGINE AND AC WITH INTEGRATED CONTROL FAN MOTOR	Ignition ON. Combustion engine AT STANDSTILL Vehicle AT STANDSTILL
ALTERNATOR DIAGNOSIS	ALTERNATOR DIAGNOSIS	DTC is not detected. Combustion engine AT STANDSTILL No charger must be connected. The charge level of the battery is OK. The battery voltage must be between 11.5 V and 15 V. Switch off air conditioning. Make sure that all current consumers are switched off.
Check coolant thermostat heating element	Check coolant thermostat heating element	Engine running at idle. Combustion engine AT STANDSTILL Vehicle AT STANDSTILL
CHECK THROTTLE VALVE ACTUATOR	CHECK THROTTLE VALVE ACTUATOR	Coolant temperature > 80 deg.C (176 deg.F) Ignition ON The combustion engine is at a standstill. Accelerator pedal NOT OPERATED
MIXTURE ADAPTATION	MIXTURE ADAPTATION	Engine speed: 400 - 800 RPM Coolant temperature between 40 deg.C (104 deg.F) and 80 deg.C (176 deg.F) Engine load: 30% or less Selector lever: P or N
AUTO STOP START	AUTO STOP START	Engine: After warning up, run engine at idle. Selector lever: N or P range "Start" and "Cancel" using CONSULT. CAUTION: Be careful so that a hood operations in the opened state when carry out work. NOTE: Before performing this test, be sure to check that "OK" is displayed on "BATTERY STS" and "SUB-BATTERY STATUS" in "DATA MONITOR" of EMCM.
CHECK FUEL PRESSURE AND INTERNAL LEAKTIGHTNESS OF FUEL SYSTEM	CHECK FUEL PRESSURE AND INTERNAL LEAKTIGHTNESS OF FUEL SYSTEM	The fuel tank must not be empty. The coolant temperature must be less than 80 deg.C. Connect pressure gauge. The fuel level must be greater than 10 liter. Run combustion engine at idle.
CHECK COOLANT PUMP SWITCHOVER VALVE	CHECK COOLANT PUMP SWITCHOVER VALVE	Coolant temperature between 70 deg.C (158 deg.F) and 90 deg.C (194 deg.F)
Throttle valve storks load up	Throttle valve storks load up	Follow the instruction of CONSULT display.
Purging switchover valve	Purging switchover valve	Follow the instruction of CONSULT display.
Check activated charcoal canister shutoff valve	Check activated charcoal canister shutoff valve	Follow the instruction of CONSULT display.
Check leak test of fuel tank	Check leak test of fuel tank	Follow the instruction of CONSULT display.
Check fuel tank pressure sensor	Check fuel tank pressure sensor	Follow the instruction of CONSULT display.
Check purging pressure control	Check purging pressure control	Follow the instruction of CONSULT display.
Check cylinder fuel injectors for leaks	Check cylinder fuel injectors for leaks	Follow the instruction of CONSULT display.