Inspection Procedure
- CHECK BATTERY TERMINALS CONNECTION
Check if battery terminals are clean and tight.
Is the inspection result normal?
YES
GO TO 2.
NO
Repair battery terminals connection.
- CHECK FUSE
Check for blown fuse and fusible link.
Unit
Power source (Power supply terminals)
Fuse No.
Alternator
Battery ("S" terminal)
69
Combination meter
Ignition switch ON ("L" terminal)
11
Is the inspection result normal?
YES
GO TO 3.
NO
Be sure to eliminate the cause of malfunction before installing new fuse.
- CHECK "E" TERMINAL CONNECTION
Check if "E" terminal (alternator ground harness) is clean and tight.
Is the inspection result normal?
YES
GO TO 4.
NO
Repair "E" terminal connection.
- CHECK DRIVE BELT TENSION
Check drive belt tension. Refer to Inspection .
Is the inspection result normal?
YES
INSPECTION END
NO
Repair as needed.