DTC Confirmation Procedure

• If DTC P26A3 is displayed with DTC P0643 first perform the trouble diagnosis for DTC P0643.
• If DTC P26A3 is displayed with DTC P26A5, P26A6, and/or P26A7 first perform the trouble diagnosis for DTC P26A5, P26A6, and/or P26A7.

Is applicable DTC detected?

YES

Perform diagnosis of applicable.

• DTC P0643: Refer to DTC Description .
• DTC P26A5: Refer to DTC Description .
• DTC P26A6: Refer to DTC Description .
• DTC P26A7: Refer to DTC Description .

NO

GO TO 2.

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TEST CONDITION:

Before performing the following procedure, confirm that battery voltage is between more than 10 V and less than 16 V at idle.

GO TO 3.

1. Turn ignition switch ON and wait at least 10 seconds.
2. Start the engine and let it idle for 60 seconds.
3. Check 1st trip DTC.

Is 1st trip DTC detected?

YES

Proceed to Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END