Component Inspection (High Pressure Fuel Pump)

1. Turn ignition switch OFF.
2. Disconnect high pressure fuel pump harness connector.
3. Check the resistance between high pressure fuel pump terminals.

   +	-	Condition		Resistance
   High pressure fuel pump
   Terminal
   1	2	Temperature deg.C (deg.F)	20 - 30 (68 - 86)	0.47 - 0.53 Ohm

Is the inspection result normal?

YES

GO TO 2.

NO

Replace high pressure fuel pump. Refer to Removal and Installation .

WITH CONSULT

1. Reconnect high pressure fuel pump harness connector.
2. Start the engine.
3. Check "FUEL PRES SEN V" in "DATA MONITOR" mode of "ECM" using CONSULT.

   Monitor item	Condition	Value
   FUEL PRES SEN V	Engine speed: idle	0.73 - 1.0 V
   	Engine speed: Revving engine from idle to 4, 000 RPM quickly	1.0 - 2.9 V

WITHOUT CONSULT

1. Reconnect high pressure fuel pump harness connector.
2. Start the engine.
3. Check FRP sensor signal voltage.

Is the inspection result normal?

YES

INSPECTION END

NO

Replace high pressure fuel pump. Refer to Removal and Installation .