Component Inspection
- CHECK CAMSHAFT POSITION (CMP) SENSOR-1
- Turn ignition switch OFF.
- Disconnect CMP sensor harness connector.
- Remove the sensor. Refer to Exploded View .
- Visually check the sensor for chipping.
Is the inspection result normal?
YES
GO TO 2.
NO
Replace the malfunctioning CMP sensor. Refer to Exploded View .
- CHECK CMP SENSOR-2
Check resistance CMP sensor terminals as follows.
CMP sensor
Resistance [at 25 deg.C (77 deg.F)]
Terminal (Polarity)
1
2
Except 0 or INF.Ohm
3
2
3
Is the inspection result normal?
YES
INSPECTION END
NO
Replace the malfunctioning CMP sensor. Refer to Exploded View .