Component Inspection (Throttle Position Sensor)

1. Turn ignition switch OFF.
2. Reconnect all harness connectors disconnected.
3. Perform Description .
4. Turn ignition switch ON.
5. Set selector lever to D position.
6. Check the voltage between ECM harness connector terminals under the following conditions.

   ECM			Condition		Voltage (V)
   Connector	+	-
   	Terminal	Terminal
   F143	43 [TP sensor 1 (bank 1)]	44	Accelerator pedal	Fully released	More than 0.36
   				Fully depressed	Less than 4.75
   F142	106 [TP sensor 1 (bank 2)]	104		Fully released	More than 0.36
   				Fully depressed	Less than 4.75
   F143	48 [TP sensor 2 (bank 1)]	44		Fully released	Less than 4.75
   				Fully depressed	More than 0.36
   F142	112 [TP sensor 2 (bank 2)]	104		Fully released	Less than 4.75
   				Fully depressed	More than 0.36

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 2.

1. Replace malfunctioning electric throttle control actuator.
2. Proceed to Description .

INSPECTION END