Work Procedure
- SAVING VEHICLE SPECIFICATION
CONSULT Configuration
Perform "Before Replace ECU", and save the current vehicle specification in CONSULT.
Is the vehicle specification saved normally?
YES
GO TO 2.
NO
GO TO 4.
- REPLACE AROUND VIEW MONITOR CONTROL UNIT
Replace around view monitor control unit. Refer to Removal and Installation .
GO TO 3.
- WRITING VEHICLE SPECIFICATION
Select "Configuration" or "After Replace ECU", and write the vehicle specification saved in CONSULT to around view monitor control unit.
GO TO 6.
- REPLACE AROUND VIEW MONITOR CONTROL UNIT
Replace around view monitor control unit. Refer to Removal and Installation .
GO TO 5.
- WRITE VEHICLE SPECIFICATION
Select "Manual Configuration", and write the setting value as shown in the following table to around view monitor control unit according to the vehicle specification.
CAUTION:- Grasp vehicle specifications precisely. The control of ECU may not function normally if the specifications are misread.
- Do not perform any operation such as the navigation operation during configuration writing.
NOTE:- The items shown in this list depend on vehicle specifications.
- The config list may not be displayed depending on vehicle specifications. This is not a malfunction.
- If selection items are not displayed on the CONSULT screen, touch "NEXT".
MANUAL SETTING ITEM
Detail
Items
Setting value
HANDLE
LHD
LHD models
RHD
RHD models
TRANSMISSION
AT/CVT
A/T models
MT
M/T models
GO TO 6.
- PERFORM SELF-DIAGNOSIS
Perform self-diagnosis of CONSULT, and check whether or not DTC U1305 is detected.
Is DTC U1305 detected?
YES
GO TO 5.
NO
GO TO 7.
- OPERATION CHECK
Check that the operation of the around view monitor control unit and camera images (fixed guide lines and predictive course lines) are normal.
WORK END