April 5, 2026: LEMON Manuals is launched! Read the announcement.

Decel G sensor calibration

CAUTION: Always use CONSULT for the decel G sensor calibration. (It cannot be adjusted other than with CONSULT.)

NOTE: Yaw rate/side/decel G sensor calibration is performed when performing the decel G sensor calibration.

CHECK THE VEHICLE STATUS
1. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
2. Stop the engine.
3. Turn the ignition switch OFF.
Is the vehicle stopped in the straight-ahead position on level surface?

YES

GO TO 2.

NO

Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
PERFORM DECEL G SENSOR CALIBRATION
CAUTION:
- Never allow passenger or load on the vehicle.
- Never apply vibration to the vehicle body when opening or closing door during calibration.
CONSULT
1. Turn the ignition switch ON.
  CAUTION: Never start engine.
2. Select "ABS", "Work support", "DECEL G SEN CALIBRATION" in this order.
3. Select "Start".
4. After approx. 10 seconds, select "End".
5. Turn ignition switch OFF and then turn it ON again.
  CAUTION: Be sure to perform the operation above.
GO TO 3.

CHECK DATA MONITOR

CONSULT

Drive the vehicle. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.

Select "ABS", "Data monitor", "ECU INPUT SIGNALS" and "DECEL G-SEN" in this order. Check that the signal is within the specified value.

DECEL G-SEN

: Approx. +/-0.08 G

Is the inspection result normal?

YES

GO TO 4.

NO

GO TO 1.

ERASE SELF-DIAGNOSIS MEMORY
CONSULT

Erase self-diagnosis result of "ABS".

Are the memories erased?

YES

GO TO 5.

NO

Check the items indicated by the self-diagnosis.
PERFORM DECEL G SENSOR CALIBRATION (TRANSMISSION)
Perform decel G calibration. Refer to Description .

YES

Inspection End.

NO