DTC Confirmation Procedure

If DTC P0046 is displayed with DTC P2562, and/or P2566 first perform the trouble diagnosis for DTC P2562, and/or P2566.

Is 1st trip DTC detected?

YES

Perform diagnosis of applicable. Refer to DTC Index .

NO

GO TO 2.

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TEST CONDITION:

Before performing the following procedure, confirm that battery voltage is between more than 11 V at idle.

GO TO 3.

1. Turn ignition switch ON and wait at least 10 seconds.
2. Start the engine and warm it up to normal operating temperature.
3. Check 1st trip DTC. (If actuator motor is stuck on the valve closing side, 1st trip DTC is detected during the above procedure. If 1st trip DTC is not detected, actuator motor may be stuck on the valve opening side. In this case, follow the instruction below.)
4. Drive the vehicle and accelerate from 20km/h (13 MPH) to 80km/h (50 MPH) within 10 seconds.
   CAUTION: Always drive at safe speed.
5. Check 1st trip DTC.

Is 1st trip DTC detected?

YES

Proceed to Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END