Diagnosis Procedure
- CHECK DTC PRIORITY
If DTC P0087 is displayed with DTC P0090 and P1197, first perform the trouble diagnosis for DTC P0090 and P1197.
Is applicable DTC detected?
YES
Perform diagnosis of applicable.
- DTC P0090: Refer to DTC Description .
- DTC P1197: Refer to DTC Description .
NO
GO TO 2.
- BLEED THE FUEL LINE
- Start the engine, and let the engine run at idle at least for 10 minutes.
- Perform DTC confirmation procedure of DTC P0087.
Is 1st trip DTC detected?
YES
GO TO 3.
NO
GO TO 7.
- CHECK LOW FUEL PRESSURE
Check low fuel pressure. Refer to Work Procedure .
Is inspection result normal?
YES
GO TO 4.
NO
Check low fuel pressure system. Refer to Diagnosis Procedure .
- CHECK LOW PRESSURE FUEL LINE FOR INTERNAL LEAKAGE
- Turn ignition switch OFF.
- Turn ignition switch ON.
- Check the following value 30 minutes after turning the ignition switch ON.
Low fuel pressure
: 206 kPa (2.1 bar, 2.2 kgf/cm2, 30 psi) or more
Is inspection result normal?
YES
GO TO 5.
NO
Replace "fuel level sensor unit and fuel pump". Refer to Removal and Installation .
- CHECK HIGH PRESSURE FUEL PUMP
Check high pressure fuel pump. Refer to Component Inspection .
Is inspection result normal?
YES
GO TO 6.
NO
Repair or replace the error-detected parts.
- CHECK HIGH PRESSURE FUEL PUMP LIFTER
Check high pressure fuel pump lifter. Refer to Removal and Installation .
Does the lifter top surface have scratches and/or dents?
YES
Replace the error-detected parts.
NO
INSPECTION END
- CHECK LOW PRESSURE FUEL LINE FOR INTERNAL LEAKAGE
- Turn ignition switch OFF.
- Connect fuel pressure gauge. Refer to Work Procedure .
- Turn ignition switch ON.
- Check the following value 30 minutes after turning the ignition switch ON.
Low fuel pressure
: 206 kPa (2.1 bar, 2.2 kgf/cm2, 30 psi) or more
Is inspection result normal?
YES
INSPECTION END
NO
Replace "fuel level sensor unit and fuel pump". Refer to Removal and Installation .