Component Inspection (Direct Fuel Injector Relay)

1. Turn ignition switch OFF.
2. Remove direct fuel injector relay 1 and 2. Refer to Component Location .
3. Check the continuity between direct fuel injector relay 1 and 2 terminals as per the following conditions.

   Direct fuel injector relay 1 and 2		Condition	Continuity
   +	-
   Terminal
   1	2	12 V direct current supply between terminals 3 and 4	Existed
   		No current supply	Not existed
   6	7	12 V direct current supply between terminals 8 and 9	Existed
   		No current supply	Not existed

Is the inspection result normal?

YES

INSPECTION END

NO

Replace direct fuel injector relay 1 and 2. Refer to Component Location .