Component Inspection (Fuel Tank Temperature Sensor)

1. Turn ignition switch OFF.
2. Disconnect "fuel level sensor unit and fuel pump" harness connector.
3. Remove fuel level sensor unit. Refer to Removal and Installation .
4. Check resistance between "fuel level sensor unit and fuel pump" terminals by heating with hot water as shown below.

   Courtesy of NISSAN NORTH AMERICA, INC.

   Fuel level sensor unit and fuel pump		Condition		Resistance
   Terminal
   7	8	Temperature [deg.C (deg.F)]	20 (68)	2.3 - 2.7 kOhm
   			50 (122)	0.79 - 0.90 kOhm

Is the inspection result normal?

YES

INSPECTION END

NO

Replace "fuel level sensor unit and fuel pump". Refer to Removal and Installation .