Power Supply Position Change Table By Push-Button Ignition Switch Operation

WARNING: This page is about a different car, the 2019 Nissan Armada and 2018 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

The power supply position changing operation can be performed with the following operations.

NOTE:

When an Intelligent Key is within the detection area of inside key antenna and when Intelligent Key backside is contacted to push-button ignition switch, it is equivalent to the operations below.
When starting the engine, the BCM monitors under the engine start conditions,
- Brake pedal operating condition
- Selector lever position
- Vehicle speed

Vehicle speed: less than 4 km/h (2.5 MPH)

Power supply position	Engine start/stop condition		Push-button ignition switch operation frequency
Power supply position	Selector lever	Brake pedal operation condition	Push-button ignition switch operation frequency
LOCK → ACC	-	Not depressed	1
LOCK → ACC → ON	-	Not depressed	2
LOCK → ACC → ON → OFF	-	Not depressed	3
LOCK → START ACC → START ON → START	P or N position	Depressed	1
Engine is running → OFF	-	-	1

Vehicle speed: 4 km/h (2.5 MPH) or more

Power supply position	Engine start/stop condition		Push-button ignition switch operation frequency
Power supply position	Selector lever	Brake pedal operation condition	Push-button ignition switch operation frequency
Engine is running → ACC	-	-	Emergency stop operation
Engine stall return operation while driving	N position	Not depressed	1

Emergency stop operation

Press and hold the push-button ignition switch for 2 seconds or more.
Press the push-button ignition switch 3 times or more within 1.5 seconds.