LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Infiniti >> 2019 >> QX80 Limited >> Repair and Diagnosis >> External Pages >> Different car >> Section 46 (Intelligent Around View Monitor System) >> Intelligent Around View Monitor System >> Basic Inspection >> Configuration (Around View Monitor Control Unit) >> Special Repair Requirement
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Special Repair Requirement

WARNING: This page is about a different car, the 2019 Nissan Armada and 2018 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Use "Manual Configuration" only when "Parts number" of around view monitor control unit cannot be read.
  • If an error occurs during configuration, start over from the beginning.
  1. CHECKING PARTS NUMBER 

    SYMBOL WITH CONSULT

    1. Select "Before Replace ECU" of "Read/Write Configuration".
    2. Check that "Parts number" is displayed on CONSULT.

    Is "Parts number" displayed?

    YES

    GO TO 2.

    NO

    GO TO 6.

  2. VERIFYING PARTS NUMBER (1) 

    SYMBOL WITH CONSULT

    Compare a "Parts number" displayed on the CONSULT screen with the one searched by using FAST (service parts catalogue) to check that these "Parts number" agree with each other.

    NOTE: For the "Parts number" searched by using FAST (service parts catalog), use the last five digits of the "Parts number".

    GO TO 3.

  3. SAVING PARTS NUMBER 

    SYMBOL WITH CONSULT

    Save "Parts number" on CONSULT.

    GO TO 4.

  4. REPLACE AROUND VIEW MONITOR CONTROL UNIT (1) 

    Replace around view monitor control unit. Refer to Removal and Installation .

    GO TO 5.

  5. WRITING (AUTOMATIC WRITING) 

    SYMBOL WITH CONSULT

    1. Select "After Replace ECU" of "Re/programming, Configuration" or that of "Read / Write Configuration".
    2. Select the "Parts number" agreeing with the one stored on CONSULT and the one searched by using FAST (service parts catalogue) to write the "Parts number" into the around view monitor control unit.

    GO TO 8.

  6. REPLACE AROUND VIEW MONITOR CONTROL UNIT (2) 

    Replace around view monitor control unit. Refer to Removal and Installation .

    GO TO 7.

  7. WRITING (MANUAL WRITING) 

    SYMBOL WITH CONSULT

    1. Select "Manual Configuration".
    2. Select the "Parts number" searched by using FAST (service parts catalogue) to write the "Parts number" into the around view monitor control unit.
      NOTE: For the "Parts number" searched by using FAST (service parts catalog), use the last five digits of the "Parts number".

    GO TO 8.

  8. VERIFYING PARTS NUMBER (2) 

    SYMBOL WITH CONSULT

    Compare a "Parts number" displayed on the CONSULT screen with the one searched by using FAST (service parts catalogue) to check that these "Parts number" agree with each other.

    NOTE: For the "Parts number" searched by using FAST (service parts catalog), use the last five digits of the "Parts number".

    GO TO 9.

  9. OPERATION CHECK 

    Confirm that each function controlled by around view monitor control unit operates normally.

    WORK END

scientia non olet · About LEMON Manuals