Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan Armada and 2018 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONTINUITY SIDE CAMERA RH POWER SUPPLY AND GROUND CIRCUIT

Turn ignition switch OFF.
Disconnect around view monitor control unit connector and door mirror (passenger side) connector.

Check continuity between door mirror (passenger side) harness connector and around view monitor control unit.

Door mirror (passenger side)		Around view monitor control unit		Continuity
Connector	Terminals	Connector	Terminals
D23	6	M61	62	Existed
	18		64

Check continuity between door mirror (passenger side) connector harness connector and ground.

Door mirror (passenger side)		Ground	Continuity
Connector	Terminals
D23	6		Not existed
	18

Is inspection result normal?

YES

GO TO 2.

Repair harness or connector.

CHECK VOLTAGE SIDE CAMERA RH POWER SUPPLY

Connect around view monitor control unit connector and door mirror (passenger side) connector.
Turn ignition switch ON.

Check voltage between around view monitor control unit harness connector and ground.

(+)		(-)	Condition	Voltage (Approx.)
Around view monitor control unit
Connector	Terminal
M61	62	Ground	"CAMERA" switch is ON or shift position is "R".	6.0 V

Is inspection result normal?

YES

GO TO 3.

Replace around view monitor control unit. Refer to Removal and Installation .

CHECK CONTINUITY SIDE CAMERA RH IMAGE SIGNAL CIRCUIT

Turn ignition switch OFF.
Disconnect around view monitor control unit connector and door mirror (passenger side) connector.

Check continuity between around view monitor control unit harness connector and door mirror (passenger side) harness connector.

Around view monitor control unit		Door mirror (passenger side)		Continuity
Connector	Terminals	Connector	Terminals
M61	65	D23	5	Existed
	66		17

Check continuity between around view monitor control unit harness connector and ground.

Around view monitor control unit		Ground	Continuity
Connector	Terminals
M61	65		Not existed
	66

Is inspection result normal?

YES

GO TO 4.

Repair harness or connector.

CHECK SIDE CAMERA RH IMAGE SIGNAL

Connect around view monitor control unit connector and door mirror (passenger side) connector.
Turn ignition switch ON.

Check signal between around view monitor control unit harness connector.

(+)		(-)		Condition	Reference value
Around view monitor control unit
Connector	Terminal	Connector	Terminal
M61	65	M61	66	"CAMERA" switch is ON or shift position is "R".	Courtesy of NISSAN NORTH AMERICA, INC.

Is inspection result normal?

YES

Replace around view monitor control unit. Refer to Removal and Installation .

Replace side camera RH. Refer to Removal and Installation .