Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan Armada and 2018 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONTINUITY SIDE CAMERA LH POWER SUPPLY AND GROUND CIRCUIT

Turn ignition switch OFF.
Disconnect around view monitor control unit connector and door mirror (driver side) connector.

Check continuity between around view monitor control unit harness connector and door mirror (driver side) harness connector.

Door mirror (driver side)		Around view monitor control unit		Continuity
Connector	Terminals	Connector	Terminals
D3	6	M61	56	Existed
	18		58

Check continuity between around view monitor control unit harness connector and ground.

Door mirror (driver side)		Ground	Continuity
Connector	Terminals
D3	6		Not existed
	18

Is inspection result normal?

YES

GO TO 2.

Repair harness or connector.

CHECK VOLTAGE SIDE CAMERA LH POWER SUPPLY

Connect around view monitor control unit connector and door mirror (driver side) connector.
Turn ignition switch ON.

Check voltage between around view monitor control unit harness connector and ground.

(+)		(-)		Condition	Voltage (Approx.)
Around view monitor control unit
Connector	Terminal	Connector	Terminal
M61	56	M61	58	"CAMERA" switch is ON or shift position is "R".	6.0 V

Is inspection result normal?

YES

GO TO 3.

Replace around view monitor control unit. Refer to Removal and Installation .

CHECK CONTINUITY SIDE CAMERA LH IMAGE SIGNAL CIRCUIT

Turn ignition switch OFF.
Disconnect around view monitor control unit connector and door mirror (driver side) connector.

Check continuity between around view monitor control unit harness connector and door mirror (driver side) harness connector.

Around view monitor control unit		Door mirror (driver side)		Continuity
Connector	Terminals	Connector	Terminals
M61	59	D3	5	Existed
	60		17

Check continuity between around view monitor control unit harness connector and ground.

Around view monitor control unit		Ground	Continuity
Connector	Terminals
M61	59		Not existed
	60

Is inspection result normal?

YES

GO TO 4.

Repair harness or connector.

CHECK SIDE CAMERA LH IMAGE SIGNAL

Connect around view monitor control unit connector and door mirror (driver side) connector.
Turn ignition switch ON.

Check signal between around view monitor control unit harness connector.

(+)		(-)		Condition	Reference value
Around view monitor control unit
Connector	Terminal	Connector	Terminal
M61	59	M61	60	"CAMERA" switch is ON or shift position is "R".	Courtesy of NISSAN NORTH AMERICA, INC.

Is inspection result normal?

YES

Replace around view monitor control unit. Refer to Removal and Installation .

Replace side camera LH. Refer to Removal and Installation .