Diagnosis Procedure

WARNING: This page is about a different car, the 2019 Nissan Armada and 2018 Nissan Armada. However, it is still accessible from the selected car via links, so may be relevant.

CHECK CONTINUITY COMMUNICATION SIGNAL CIRCUIT

Turn ignition switch OFF.
Disconnect around view monitor control unit connector and door mirror (driver side) connector.

Check continuity between around view monitor control unit harness connector and door mirror (driver side) harness connector.

Around view monitor control unit

Door mirror

(driver side)

Continuity

Connector

Terminal

Connector

Terminal

M61

Existed

Check continuity between around view monitor control unit harness connector and ground.

Around view monitor control unit		Ground	Continuity
Connector	Terminal
M61	55		Not existed

Is inspection result normal?

YES

GO TO 2.

Repair harness or connector.

CHECK COMMUNICATION SIGNAL

Connect around view monitor control unit connector and door mirror (driver side) connector.
Turn ignition switch ON.

Check signal between around view monitor control unit harness connector and ground.

(+)		(-)	Condition	Reference value
Around view monitor control unit
Connector	Terminal
M61	55	Ground	"CAMERA" switch is ON or shift position is "R".	Courtesy of NISSAN NORTH AMERICA, INC.

Is inspection result normal?

YES

Replace around view monitor control unit. Refer to Removal and Installation .

Replace side camera LH. Refer to Removal and Installation .