Component Inspection
- CHECK INTAKE CAMSHAFT POSITION (CMP) SENSOR-I
- Turn ignition switch OFF.
- Disconnect intake CMP sensor harness connector.
- Remove the sensor. Refer to CAMSHAFT : Exploded View .
- Visually check the sensor for chipping.
Is the inspection result normal?
YES
GO TO 2.
NO
Replace the malfunctioning intake CMP sensor. Refer to CAMSHAFT : Exploded View .
- CHECK INTAKE CMP SENSOR-II
Check resistance intake CMP sensor terminals as follows.
Intake CMP sensor
Condition
Resistance
Terminal (Polarity)
1
2
Temperature [Deg. C (Deg. F)]
25 (77)
Except 0 or infinite Ohms
3
2
3
Is the inspection result normal?
YES
INSPECTION END
NO
Replace the malfunctioning intake CMP sensor. Refer to CAMSHAFT : Exploded View .