Self Diagnostic Result Mode

Self Diagnostic Item

Regarding items of DTC and 1st trip DTC, refer to DTC Index .

How to Read DTC and 1st Trip DTC

DTCs and 1st trip DTCs related to the malfunction are displayed in "Self-diag results" mode with CONSULT. "TIME" indicates the number of driving the vehicle after the last detection of DTC.

When ECM has detected a current DTC, "0" is displayed for "TIME".
When ECM memorizes a 1st trip DTC, "1t" is displayed for "TIME".
If "TIME" is neither "0" nor "1t", the DTC occurred in the past.

How to Erase DTC

NOTE: If the ignition switch stays ON after repair work, be sure to turn ignition switch OFF once. Wait at least 10 seconds and then turn it ON (engine stopped) again.

Freeze Frame Data and 1st Trip Freeze Frame Data

Freeze frame data item* ¹	Description
DIAG TROUBLE CODE [PXXXX]	The engine control component part/control system has a trouble code displayed as PXXXX. (Refer to DTC Index .)
CAL/LD VALUE %]	The calculated load value at the moment a malfunction is detected is displayed.
COOLANT TEMP [ deg. C]	The engine coolant temperature at the moment a malfunction is detected is displayed.
L-FUEL TRM-B1 %]	"Long-term fuel trim" at the moment a malfunction is detected is displayed. The long-term fuel trim indicates much more gradual feedback compensation to the base fuel schedule than short-term fuel trim.
L-FUEL TRM-B2 %]
S-FUEL TRM-B1 %]	"Short-term fuel trim" at the moment a malfunction is detected is displayed. The short-term fuel trim indicates dynamic or instantaneous feedback compensation to the base fuel schedule.
S-FUEL TRM-B2 %]
ENGINE SPEED [ rpm]	The engine speed at the moment a malfunction is detected is displayed.
VEHICL SPEED [km/h] or [mph]	The vehicle speed at the moment a malfunction is detected is displayed.
ABSOL TH.P/S [%]	The throttle valve opening angle at the moment a malfunction is detected is displayed.
INJ PULSE [msec]	The basic injection quantity at the moment a malfunction is detected is displayed.
INT/A TEMP SE [ deg. C] or [ deg. F]	The intake air temperature at the moment a malfunction is detected is displayed.
FUEL SYS-B1	"Fuel injection system status" at the moment a malfunction is detected is displayed. One of the following mode is displayed. MODE 2: Open loop due to detected system malfunction MODE 3: Open loop due to driving conditions (power enrichment, deceleration enleanment) MODE 4: Closed loop - using oxygen sensor (s) as feedback for fuel control MODE 5: Open loop - has not yet satisfied condition to go to closed loop
FUEL SYS-B2
INT MANI PRES [kPa]	Constant value is displayed. These items are displayed but are not applicable to this model.
COMBUST CONDITION
FUEL RAIL PRESSURE [MPa]	The fuel rail pressure at the moment a malfunction is detected is displayed.
TARGET FUEL RAIL PRESSURE [MPa]	The target fuel rail pressure at the moment a malfunction is detected is displayed.
BATTERY VOLTAGE [V]	The battery voltage at the moment a malfunction is detected is displayed.
FUEL LEVEL [%]	The fuel level at the moment a malfunction is detected is displayed.
ODO/TRIP METER	The ODO/TRIP at the moment a malfunction is detected is displayed.
B/FUEL SCHDL [msec]	The base fuel schedule at the moment a malfunction is detected is displayed

*1: The items are the same as those of 1st trip freeze frame data.