April 5, 2026: LEMON Manuals is launched! Read the announcement.

Decel G sensor calibration

CAUTION: Always use CONSULT for the decel G sensor calibration. (It cannot be adjusted other than with CONSULT.)

NOTE: Yaw rate/side/decel G sensor calibration is performed when performing the decel G sensor calibration.

CHECK THE VEHICLE STATUS
1. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
2. Stop the engine.
3. Ignition switch OFF.
Is the vehicle stopped in the straight-ahead position on level surface?

YES

GO TO 2.

NO

Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.
PERFORM DECEL G SENSOR CALIBRATION
CAUTION:
- Never allow passenger or load on the vehicle.
- Never apply vibration to the vehicle body when opening or closing door during calibration.
CONSULT
1. Ignition switch ON.
  CAUTION: Never start engine.
2. Select "DECEL G SEN CALIBRATION" in "Work support" mode of "ABS".
3. Select "Start".
4. After approx. 10 seconds, select "End".
5. Ignition switch OFF and then place the ignition switch in the ON position again.
  CAUTION: Be sure to perform the operation above.
GO TO 3.

CHECK DATA MONITOR

CONSULT

Drive the vehicle. Steer the steering wheel to the straight-ahead position. Stop the vehicle on level surface.

Select "ECU INPUT SIGNALS" and "DECEL G SENSOR" in "Data Monitor" mode of "ABS". Check that the signal is within the specified value.

DECEL G SEN

: Approx. +/-0.08 G

Is the inspection result normal?

YES

GO TO 4.

NO

GO TO 1.

ERASE SELF DIAGNOSTIC RESULT MEMORY
CONSULT

Erase "Self Diagnostic Result" mode of "ABS".

Are the memories erased?

YES

GO TO 5.

NO

Check the items indicated by the self-diagnosis.
PERFORM DECEL G SENSOR CALIBRATION (TRANSMISSION)
Perform decel G calibration. Refer to Description .

YES

Inspection End.

NO