Component Inspection
- CHECK ACCELERATOR PEDAL POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Turn ignition switch ON.
- Check the voltage ECM harness connector terminals under the following conditions.
ECM
Condition
Voltage (V)
Connector
+
-
Terminal
Terminal
E20
150 (APP sensor 1)
151
Accelerator pedal
Fully released
0.5 - 1.0
Fully depressed
4.2 - 4.8
143 (APP sensor 2)
144
Fully released
0.25 - 0.5
Fully depressed
2.0 - 2.5
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO 2.
- REPLACE ACCELERATOR PEDAL ASSEMBLY
Replace accelerator pedal assembly. Refer to ACCELERATOR PEDAL ASSEMBLY : Removal & Installation .
INSPECTION END