Component Inspection
- CHECK THROTTLE POSITION SENSOR
- Turn ignition switch OFF.
- Reconnect all harness connectors disconnected.
- Perform Refer to Work Procedure .
- Turn ignition switch ON.
- Set selector lever position to D.
- Check the voltage between ECM harness connector terminals under the following conditions.
ECM
Condition
Voltage (V)
Connector
+
-
Terminal
Terminal
F92
78
(TP sensor 1 signal)
85
(Sensor ground)
Accelerator pedal
Fully released
More than 0.36
Fully depressed
Less than 4.75
80
(TP sensor 2 signal)
Fully released
Less than 4.75
Fully depressed
More than 0.36
Is the inspection result normal?
YES
INSPECTION END
NO
GO TO 2.
- REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
Replace electric throttle control actuator. Refer to INTAKE MANIFOLD : Removal & Installation .
INSPECTION END