DTC Description
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detected condition | |
|---|---|---|---|
| C13C5-00 | STEERING ANGLE SENSOR SIGNAL (Steering angle sensor signal) | Diagnosis condition | When ignition switch ON |
| Signal (terminal) | - | ||
| Threshold | Malfunction is detected in steering angle sensor signal that is output from steering angle sensor. | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
- Harness or connector (CAN communication line)
- Steering force control module
- Steering angle sensor
FAIL-SAFE
Mode 2
NOTE:
For fail-safe mode, refer to Steering Force Control Module Fail-safe
.
DTC CONFIRMATION PROCEDURE
- PRECONDITIONING
- If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.
>>
GO TO 2.
- DTC REPRODUCTION PROCEDURE
CONSULT
- Ignition switch ON.
- Erase "Self Diagnostic Result" mode of "EPS/DAST 3".
Is DTC "C13C5-00" detected?
YES>>
Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure .
NO>>
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO>>
Confirmation after repair: Inspection End.