DTC Confirmation Procedure

If DTC P10B0 is displayed with DTC 10B1, first perform the trouble diagnosis for DTC 10B1.

Is applicable DTC detected?

YES

Perform diagnosis of applicable. Refer to DTC Description .

NO

GO TO 2.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION:

Before performing the following procedure, confirm that battery voltage is 11 V or more at idle.

GO TO 3.

1. Turn ignition switch ON (engine stopped) and wait least 10 seconds.
   CAUTION: Never start engine during this procedure.
2. Turn ignition switch OFF and wait at least 10 seconds.
3. Turn ignition switch ON.
4. Check DTC.

Is DTC detected?

YES

Proceed to Diagnosis Procedure .

NO

To check malfunction symptom before repair: Refer to Intermittent Incident .

NO

Confirmation after repair: INSPECTION END