DTC Confirmation Procedure
- PRECONDITIONING
If "DTC CONFIRMATION PROCEDURE" has been previously conducted, always place ignition switch OFF and wait at least 10 seconds before conducting the next test.
GO TO 2.
- DTC REPRODUCTION PROCEDURE
CONSULT
- Ignition switch ON.
- Select "Self Diagnostic Result" mode of "EPS/DAST 3", "DAST 1" or "DAST 2".
Is DTC "C13BD-00" detected?
YES
Proceed to diagnosis procedure. Refer to Diagnosis Procedure .
NO
To check malfunction symptom before repair: Refer to Intermittent Incident .
NO
Confirmation after repair: Inspection End.