April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis Procedure

NOTE:

Check the stop/start system operation condition. Refer to System Description .

CHECK STOP/START PROHIBIT CAUSE
1. With CONSULT: Select "Stop/Start prohibit cause data recorder" in "WORK SUPPORT" mode of "ENGINE" using CONSULT.
Does "Stop/Start prohibit cause data recorder" show fail-safe?

YES>>

GO TO 2.

NO>>

Check the operating status of system stop / start. Refer to System Description . After confirmation, go to 4.
CHECK "Stop/Start error" OF CONSULT DATA MONITOR ITEM
1. With CONSULT
  1. Select "Stop/Start error" in "Monitor Menu" of "DATA MONITOR" mode in CONSULT.
  2. Check the displayed data monitor items. Refer to CONSULT Function .
Are there any "NG" monitor items?

YES>>

After confirming the "NG" item, go to 3.

NO>>

GO TO 3.
CHECK DTC
1. With CONSULT Perform "All DTC Reading" with CONSULT.
Does it detect the DTC associated with "Stop/Start error" of "DATA MONITOR"?

YES>>

Perform trouble diagnosis of detected DTC. After repairing the defective part, go to 4.

NO>>

GO TO 4.

CHECK STOP/START INDICATOR / LAMP

Check the stop/start indicator / lamp.

WARNING LAMP/INDICATOR LAMP / INDICATOR	CONDITION
Stop/start indicator / lamp	Not blinking

Is the stop/start indicator / lamp blinking?

YES>>

Refer to Symptom Table .

NO>>

INSPECTION END