Component Inspection

1. Turn ignition switch OFF.
2. Disconnect engine coolant temperature sensor 1 harness connector.
3. Remove engine coolant temperature sensor 1.
4. Check resistance between engine coolant temperature sensor 1 terminals by heating with hot water as shown in the figure.

   Courtesy of NISSAN NORTH AMERICA, INC.

   Terminals	Condition		Resistance (kOhm)
   1 and 2	Temperature [ deg.C. (deg.F)]	20 (68)	2.35 - 2.73
   		50 (122)	0.68 - 1.00
   		90 (194)	0.236 - 0.260

Is the inspection result normal?

YES

INSPECTION END

NO

Replace engine coolant temperature sensor 1. Refer to CYLINDER HEAD : Exploded View .