Component Inspection

1. Turn ignition switch OFF.
2. Disconnect stop lamp switch harness connector.
3. Check the continuity between stop lamp switch terminals under the following conditions.

   Terminals	Condition		Continuity
   1 and 2	Brake pedal	Fully released	Not existed
   		Slightly depressed	Existed

Is the inspection result normal?

YES

INSPECTION END

NO

GO TO 2.

1. Adjust stop lamp switch installation. Refer to BRAKE PEDAL : .
2. Check the continuity between stop lamp switch terminals under the following conditions.

   Terminals	Condition		Continuity
   1 and 2	Brake pedal	Fully released	Not existed
   		Slightly depressed	Existed

Is the inspection result normal?

YES

INSPECTION END

NO

Replace stop lamp switch. Refer to BRAKE PEDAL : Removal & Installation .