Work Procedure

Initialize the system if any of the following work has been done. Refer to Work Procedure .

• When control unit replaced.
• Electric power supply to power window switch or motor is interrupted by blown (open) fuse or disconnection and connection of the negative terminal of battery, etc.
• Removal and installation of regulator assembly.
• Power supply to the power window main switch or power window motor is cut off by the removal of battery terminal or if the battery fuse is blown (open).
• Disconnection and connection of power window main switch harness connector.
• Removal and installation of motor from regulator assembly.
• Operation of regulator assembly as an independent unit.
• Removal and installation of door glass.
• Removal and installation of door glass run.

The following specified operations can not be performed under the non-initialized condition.

• Auto-up operation
• Anti-pinch function

1. STEP 1 
   1. Close the door.
   2. Turn ignition switch ON.
   3. Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open)

   >>

   GO TO 2.

2. STEP 2 

   Continue pulling the power window switch UP (AUTO-UP operation). Even after glass stops at fully closed position, keep pulling the switch for 2 seconds or more.

   >>

   GO TO 3.

3. STEP 3 

   Check that auto-up function operates normally.

   >>

   GO TO 4.

4. STEP 4 

   Check anti-pinch function. Refer to Work Procedure .

   >>

   END